6.4 Powerstroke EGR Blocker Plate Kit

$74.99 $49.99

The lower plate is installed just prior to the first/horizontal EGR the runs along the left side of the engine back to front. This plate will allow exhaust flow and pressure to still reach the Exhaust Back Pressure sensor located in the EGR cooler feed pipe that runs from the back of the turbo's down to the left side of the engine. The block off plate with be installed by loosening (but you don't have to remove the bolts) enough to spread the pipes apart and slide the block off plate in front of the gasket. The plate is made with cut out bolt holes to allow this to be installed without disconnecting the EGR cooler feed pipe and the horizontal first EGR cooler (located along the left side/driver side of the engine). If you are working alone it is best to remove the left inner fender well for this install. It can be done from the bottom of the truck with a helper from the top or side to spread the two pipes apart. You must run the proper EGR programming to prevent a CEL.

Last Updated: Monday, 22 October 2018 19:24